SPECIFICATIONS
Ice Cream Tools Type: Ice Cream Makers
Feature: Eco-Friendly
Type: Ice Cream Tools
Material: Silicone
Description
Product Information:
You can use this silicone ice cube tray to make various beverages you like in your cups, such as whiskey, cocktails, wine, and cola. It can hold
60 ice cubes. Suitable for summer parties, hotels, restaurants, bars, picnics, and more, which will bring more fun.
How to Use:
1. Pull out the inner cylinder, pour water into the silicone container, and the position that is slightly more than 2 grids does not exceed 2 and a half grids.
2. Slowly insert the inner cylinder with the cover into the silicone cavity, pay attention to rotating it to the bottom and holding it down, and then gently squeeze the silicone side exhaust under the cover to prevent the inner cylinder from floating.
3. Snap the lid onto the ice bucket. Put in the refrigerator until all the water freezes. (4-6 hours).
4. Put the mold at room temperature for a few minutes; if you don't want to wait and press hard, you can pour an appropriate amount of hot water into the inner cylinder for about 10 seconds, pour out the hot water, and you can easily pull out the inner cylinder.
5. Once frozen, remove the ice bucket from the refrigerator. Remove the cover and squeeze firmly on all sides of the outer cavity.
Tips:
1. The bucket in the middle is pulled out after freezing.
2. It is recommended to be frozen for 4-6 hours.
3. Please do not use strong detergent to clean the ice bucket to avoid corrosion. Keep these ice buckets away from the fire to prevent them from deforming.
Specification:
1. Product name: Cylinder ice tray
2. Material: food-grade silicone + ABS
Size:
1. Mold: about 9*8*8.5cm/3.54*3.15*3.35in
2. Ice cube: about 1.3cm
3. Number of ice cubes: 60 cubes
Package List:
1* ice bucket
Kindly Note:
1. Please allow 1-2cm error due to manual measurement and make sure you do not mind before purchase.
2. The color of the actual item may slightly vary from the images due to different computer screens and display settings.
Thanks for your understanding
